12v Power Strobe Complete board for Warning lights
REV:3.0 - A medium power low-energy, high repetition Xenon strobe, suitable for Warning lights and stage effects.
• Repeating strobe - the module flashes repeatingly while it is powered
• On-demand single flash - a pulse fed to the module will trigger a flash
This module is a Powerful high voltage capacitor charger including the trigger coil and the common linear flash tube L-4040 mounted on board.
Selectable trigger method : The module is available in two versions:
• Repeating strobe - the module flashes repeatingly while it is powered.
• On-demand single flash - a low voltage pulse fed to the module will trigger a single flash
- Fast pulse : The on-board Polypropylene capacitor mounted on the bottom side, provides High-energy, Low-ESR and thus a Short pulse duration, ideal for timing application.
- CUSTOMIZABLE: You can easily modify the module's capacitor according to the flash-energy you need, as well as modify, or connect an external flash tube.
Module Specifications
•Input Voltage: 9-17v
•Default Flash Tube: L-4036 (Linear 36mm)
•Output capacitor voltage: ~410v
•Flash energy: ~400mJ
•Trigger coil output: 6Kv
•Module dimensions: 46x55x21 mm
•Trigger input: 5-12v pulse
•Triggering method: Repeating or Single trigger input
Details, Wiring diagram
WARNING: This kit involves High Voltage up to 800v which is stored in big capacitors even long after turning the unit off. THIS VOLTAGE CAN CAUSE SEVERE DAMAGE AND INJURY. Never touch any of the components and always discharge the capacitor before working on it. Always keep in a well insulated project enclosure.
BY FOLLOWING THESE INSTRUCTIONS YOU AGREE TO BE THE ONLY RESPONSIBLE FOR ANY DAMAGE THAT MIGHT BE CAUSED BY DOING SO. WORK CAREFULLY AND FOLLOW WARNINGS
Connection scheme
According to the following scheme, connect the power wiring following the right polarity.
If you ordered the Single flash on trigger input version, connect the trigger input wire as well.
A positive 5-12v pulse should be applied to this input in order to trigger the flash.
Data sheet
- Max. Flash Energy
- 400mJ
- Input voltage
- 12v DC
- Voltage range
- 9v-17v
- Output voltage (Max.)
- 410v
- Charge rate (Max)
- 10J/S
- Current draw (Max)
- 700mA
- Output isolation
- Non-Isolated
- PCB Dimensions
- 46x55mm
- Lamp included
- With Lamp
- Capacitor included
- With Capacitor
- Application field
- Stage strobes
- Application field
- Signal lights
- Flash Rate (max)
- 8-20Hz
Data sheet
- Max. Flash Energy
- 400mJ
- Input voltage
- 12v DC
- Voltage range
- 9v-17v
- Output voltage (Max.)
- 410v
- Charge rate (Max)
- 10J/S
- Current draw (Max)
- 700mA
- Output isolation
- Non-Isolated
- PCB Dimensions
- 46x55mm
- Lamp included
- With Lamp
- Capacitor included
- With Capacitor
- Application field
- Stage strobes
- Application field
- Signal lights
- Flash Rate (max)
- 8-20Hz